All the RJ45 serial ports located on the rear panel of the IM7200 ship by default configured with the Cisco Straight pinout. However any individual port (or multiple ports) can be software configured so they have a Cisco Rolled pinout:
- Set the Port Pinout under the Common Settings of the Serial & Network: Serial Port menu. Note: This Port Pinout menu item only presents on the menu for IM7200
- Select either X2 (Cisco Straight) or X1 (Cisco Rolled)
- Click Apply
- To configure the pinout for all the IM7200 ports check Select/Unselect all Ports
Note: In the event that you do not see this option, you may need to enable it through the CLI by entering the following command.
# setfset -u factory_opts=switchable_pinout
Comments
0 comments
Article is closed for comments.