Setting UPS Battery Status as Check Condition

The Auto-Response facility (in all console servers with Firmware V3.5.1 and later) monitors nominated ports/ devices / probes/ states for Check Condition to trigger action sequences. To use the the alert state of any attached UPS as the trigger event:

• Click on UPS Status as the Check Condition
• Select the reported UPS State to trigger the Auto-Response (either On Battery or Low Battery). The Auto-Response will resolve when the UPS state returns to the "Online" state
• Select which connected UPS Device to monitor and check Save Auto-Response
• Check Save Auto-Response 
  
   

Note: Before configuring UPS state checks in Auto-Response you first must configure the attached UPS . 

Note: For general info on monitoring, auto-response (and alert config pre V3.5.1) refer faq409-Auto-Response-Alerts