Lighthouse 2020.Q2.1 is Generally Available.
Fixes and Features:
- Fixed Web Terminal problems (sometimes not loading properly or restarting) - Fixed issue with spurious SNMP server restarts on secondary Lighthouses - Fixed issue with SNMP not reporting node information accurately after restarting some system services - Fixed issue with some Cell Health SNMP traps being sent, regardless of status change - Fixed issue with log file partitions filling up due to excessively large log files - Fixed issue with slow Web UI responsiveness if the private VPN range is changed from the default - Fixed issue with incorrect response codes to console servers during enrollment with many parallel enrollments - Fixed issue with many parallel enrollments becoming bottlenecked and timing out - Fixed issue with config retrieval job failures on nodes with poor connectivity
- The number of nodes connected to a secondary Lighthouse will be listed as unknown if the connection between the two Lighthouses is broken. - If a remote authentication server is configured, but it is down, there may be a delay or a failure in authenticating local users via the web UI. - When applying configuration templates, ensure the set of nodes you are pushing to is a small number (<50), large pushes can take a long time to complete. - Due to improvements in the network validation routines, please check the correctness of network settings before upgrading. Specifically if a device is being assigned the same address both statically and via DHCP, this will now cause validation failures which may result in an upgrade rollback. - Virtual Machines with less than 8GB of RAM may exhibit some instability, and may fail loading a firmware upgrade file via the web interface. We recommend at least 8GB of RAM for Lighthouse. - If the Lighthouse VM is configured with IPv6, but the network it is attached to does not support/provide IPv6 addresses, the web interface may show the IPv6 address as "undefined/undefined".
If you have a previous version of Lighthouse installed, it is advised that you take a VM snapshot of your installation.
It is suggested that you clear your browser cache - as some browsers will not auto-update the firmware revision information listed in Lighthouse.