Network configuration
This section covers basic networking configuration for physical interfaces
- Configure an interface with a static IP
- Configure an interface as a DHCP client
- Bonding using LACP (Link Aggregation Control Protocol)
- Configure Dynamic DNS (DDNS)
- Configure IPv6
- Configure an interface as a DHCP server
- Initial network connection
- Configuring network interface(s) from command line
- IP address assignment using arp - ping
- Can I use an Opengear device as a gateway router?
- Setting up the firewalled client that's attached to the Opengear device
- Broadband out-of-band access via secondary Ethernet (cable, DSL modem)
- Generic Routing Encapsulation (GRE) tunnelling from the command line
- Automatic failover to alternate broadband, cellular or dial-out Internet connection